Sale!

DIP 3 Color LED Module

97.00

  1. The use of plug-in full-color LED.
  2. RGB trichromatic limiting resistor to prevent burnout.
  3. Through the PWM adjusting, three primary colors can be mixed to obtain different colors.
  4. With a variety of single-chip interface.
  5. The working voltage: 5V.
  6. LED drive mode: common cathode driver
SKU: RK009869 Categories: ,

Description

This module consists of a 5mm RGB LED and three 150Ω limiting resistors to prevent burnout. Adjusting the PWM signal on each colour pin will result in different colours.

This is a DIP 3 Color LED Module. Through the PWM adjusting, three primary colours can be mixed to obtain different colours.

Connect the red pin (R) on the KY-016 to pin 11 on the Arduino. Blue (B) to pin 10, green (G) to pin 9 and ground (-) to GND. Notice that you do not need to use limiting resistors since they are already included on the board.

Connection Diagram:

 

Pin Connection with Arduino:
LED moduleArduino
RPin 11
BPin 10
GPin 9
GND

 


Features :

  1. The use of plug-in full-colour LED.
  2. RGB trichromatic limiting resistor to prevent burnout.
  3. With a variety of single-chip interface.
  4. Through the PWM adjusting, three primary colours can be mixed to obtain different colours
  5. The working voltage: 5V

Package Includes :

1 x DIP 3 Color LED Module.

Reviews

There are no reviews yet.

Be the first to review “DIP 3 Color LED Module”

Your email address will not be published. Required fields are marked *